Fundamentals of Fluid Mechanics Questions and Answers  
Question by AME536A Student
For A8Q1 a, when determining the stagnation points setting $v_r$ and $v_{\theta}$ equal to zero, I find a location for the stagnation point set by $$x=\frac{-Q}{2\pi U}$$ and $$y=0,\pi$$ I think the expression for x makes very little sense as the units would be meters squared, if I assume Q is in terms of volumetric flow rate. In the example problem you set Q = -Uh, so I was wondering if that can be the case for this problem too, or not.
11.06.21
Yes, the units for $Q$ will be the same either in the example problem in class or in this problem.
Question by AME536A Student
Follow-up to the question above: I know the units of Q are the same but what I was confused about was whether Q= -Uh in this problem too.
11.07.21
Is it mentioned in the problem statement that $Q=-Uh$? If not, then it is most probably not equal to this.
Question by AME536A Student
Dr. Parent, will you still have additional office hours on Mondays from 5-6 pm?
11.17.21
Yes, from now the office hours are every Monday from 1-2 pm and from 5-6 pm.
Question by AME536A Student
Hi Dr. Parent. I'm working on the first problem for assignment 9 and am having a hard time getting started. My initial approach has been as follows: Find $\Psi$ as the sum of $$(\Psi) _{uniform} + (\Psi)_{Doublet}$$ along the streamline where $$r = R$$ and then using this equation to find $v_r$ and $v_{\theta}$. I am doing all of this so I can find an expression for P in terms of $\theta$ using Bernoulli's equation. This answer, however, yields me a Pressure term in terms of r only as the final answer for this becomes: $$q^2 = U_{\infty}(1-{R^2}/{r^2})^2(cos^2({\theta})+sin^2({\theta}))$$ which simplifies to $$q^2 = U_{\infty}(1-{R^2}/{r^2})^2$$ I'm assuming there is a flaw in my initial logic but I'm not sure where it is. Is there any way you can nudge me in the right direction? Thanks!
11.21.21
The pressure will change at $r=R$ because $v_{\theta}$ changes. First find $v_{\theta}$ at $r=R$.
Question by AME536A Student
For assignment 9 Question 1, I find that the drag is equal to $$\vec{F} = \frac{4}{3}\rho U_{\infty}R$$ I am off by a factor of 2, and I was wondering whether that might be because I used the wrong streamfunction solution. I used the cylinder fundamental solution to find the velocities, and plug them into Bernoulli's equation, but I am not sure if I should have used the uniform fundamental solution too, in addition to the cylinder one. Any feedback is appreciated!
Using the cylinder fundamental solution is ok to find the pressure on some parts of the body, but not on all.
Previous   1  ...  32 ,  33 ,  34  ...  39    Next  •  PDF 1✕1 2✕1 2✕2
$\pi$