Fundamentals of Fluid Mechanics Questions and Answers  
Question by AME536A Student
I have a question about the problem #3 in the assignment 5. Is the pipe suspended in the air by the holder? or are all components consisting of the system, including wedge, pipe and water, falling down by the gravitational acceleration?
10.11.20
Sure, the pipe and wedge are held at the same location with respect to the ground using a holder.
Question by AME536A Student
In problem 2 of homework 5 I am finding some difficulties with velocities at the outlets (sections 2 and 3). Using the mass conservation equation and the momemtum equation in the tangent direction of the plate I am able to find two equations to calculate the mass flow rates that the problem asks for as a function of the angle $\theta, q_{01}, q_{02}, q_{03}$.

In order to calculate $q_{02}$ and $q_{03}$ I intended to use Bernoulli's equation. However, if I neglect the gravity terms I end up getting, $$ q_{02}=q_{01} $$ $$ q_{03}=q_{01} $$ and then the equations I previously got make no longer sense. Where is the mistake in my reasoning?
I don't understand your question. First, you mention you can find the answer asked for if given $q_{01}$, $q_{02}$, etc. Then you find a way to determine these velocities. So what is your question?
Question by AME536A Student
My question is where am I wrong because if $q_{02}=q_{01}$ and $q_{03}=q_{01}$ then the result I get is an indetermination since my equation is, $$ \frac{m_{2}}{m_{1}} = \frac{q_{01}cos\theta - q_{03}}{q_{02}-q_{03}} $$
Ah, now I understand your question. Well, this means you made a mistake somewhere which you need to find... You can not have a division by zero here. Look into your solution carefully and find the bug.
Question by AME536A Student
Follow up question to the one asked on 10/10 about problem 2. I solved the momentum equation in the longitudinal and transverse directions of the plate, and have the mass conservation equation. This yields me with 3 equations and 4 unknowns ($\dot{m}_1$, $\dot{m}_2$, $\dot{m}_3$, and F). I have not been able to find a suitable equation in the tables to sole for my fourth unknown. Is there a 4th equation that I am missing, or is it intended that we make an assumption about the cross sectional area of the input flow for $\dot{m}_1$ to solve this problem?
You don't need to specify the cross-sectional area of the incoming flow or the mass flow rate of the incoming flow to solve this problem.
Question by AME536A Student
Is there a fourth equation that is relevant to this problem (excluding Bernoulli's)?
If we have seen it in class so far, and is listed in the tables it is possibly applicable. What equations have we seen? Which ones could you use? List them and think about why or why not some equations can be used here.
Previous   1  ...  9 ,  10 ,  11  ...  39    Next  •  PDF 1✕1 2✕1 2✕2
$\pi$